Hello,
I have a SW11-ESP-2EU touch wall switch.
It is equiped with an SW-03-ESP8285 ESP chip.
I cannot flash it through web or OTA because I disabled OTA by mistake.
How can I flash it through USB ? I cannot find the pinout for VCC, GND, TX & RX
Thank you for your help
Best regards
UPDATE:
I succesfully flashed the ESP with the following wiring:
GND --> GND
3v3 --> VCC
EN --> 3v3
GPIO0 --> GND
TX --> RX
RX --> TX
NB: USB TTL adapter pins are the ones on the left in my list
I had to keep this wiring when pluging my USB TTL adapter up to the end of the flashing process.
Hope it will help others
https://tasmota.github.io/docs/devices/TYWE3S/