Hello everybody,
I bought a couple of LS4P controllers, but I am struggling with setting up the WLED. I am powering the controller with a 5V external power supply and without a light strip attached. There seeems to be voltage going in the controller (check it with a multimeter), but the WLED AP is not showing. I tried holding the button down for a number of seconds but it did not work either. I tried with another controller, thinking that I could have messed up the wiring (which I did not), but the result was the same - no AP showing. Could you give me a guide on how to proceed? I figured out I might have to manually flash the controller, but I am clueless on how to do that.
Thanks in advance!
Good day,
Can you send me instructions instructions on how to flash the esp? Do I have to enter the esp into boot mode and do I have to connect any pins together? I have a USB to TTL module but I am unable to connect to the device to upload the firmware.
Try to reset the device by pressing the button for more than 10 seconds. If that doesn't work, you can only open the case and re-flash the firmware.