Did someone manage to get the INA226 usermod running on a self compiled 0.16 WLED?
What is the built in sense resistance value (1000mOhm?) and the address of the INA266. I do not get any data from the default values using address 64
EDIT:
It works if you
compile WLED 0.16 with usermod INA266 (its just one click in Visual Studio Code, see WLED documentation)
set Rsense to 5mOhm
set I2C from "unused" to the pin numbers INA_SDA：GPIO19 and INA_CLK：GPIO4
that’s good to hear - i’ll give it a go again tonight
I confirmed with an oscilloscope that the I2C address on the INA266 was set to 40h=64 (as it is the default) and with an microscope that the sense resistor setting should be 5mOhm as there is a 5mOhm sense resistor right next to the INA266 chip on the board
does anyone have the link to the factory 0.14.4 f/w for this device ?
i’m not able to get the INA working on 0.15 let alone 0.16 ;)
INA_SDA：GPIO19
INA_CLK：GPIO4