• Home

  • Products

    • Local Shipping
    • Tasmota
    • ESPHome
    • WLED
    • Homekit
    • Home Bridge
  • Forum

  • About Shipping

  • Contact Us

  • 更多

    Use tab to navigate through the menu items.
    0
    Pour voir cela fonctionner, rendez-vous sur votre site en ligne.
    • Catégories
    • Tous les posts
    • Mes posts
    pablomedok
    09 déc. 2020

    Wifi reconnect

    dans Wall Switch

    Is there a way to configure auto-reconnect or at least a power on connection delay.


    I have a Homekit version of 2 gang switch with mechanical buttons that is installed in my summer house. It controls outside lights via Homekit automations. Power supply for the house is not stable, so it loses power a couple of times a month. Every time power recovers the switch tries to reconnect to the wifi-router, but it's not ready yet (it takes up to 2 minutes to initialize). Or maybe the swithc resets after a power outage? If so, that's even worse. So, the switch stays disconnected (with a pink LED) in unknown state (on or off) until I come to the house and reset connection to the Wifi.


    Is there a way to solve this problem?

    7 commentaires
    0
    7 commentaires

    Partagez vos idéesInscrivez-vous pour laisser un commentaire.

    E
    Eliza Bala
    Eliza Bala
    06 sept. 2021

    It often comes into question what is the best wall mount for such big TVs, can you mount a 75-inch tv on the wall, are tv wall mounts universal, what size screws are used to mount a Samsung tv, and even can you hang a curved tv on a regular wall mount? Read till the end to have all such questions answered.

    There is also a guide in the end after https://wallmountedhub.com/best-wall-mounts-for-82-inch-tv/

    J'aime

    pablomedok
    14 juil. 2021

    I've already contacted and I was told that my version of athom switch is not supported. Which is dumb.

    J'aime

    Athom_Support
    14 juil. 2021

    If you need to upgrade, please contact by email, support@athom.tech

    J'aime

    Athom_Support
    02 juin 2021

    If the current version is greater than or equal to 0.3, it can be solved by upgrading the firmware, if you want to upgrade, you can contact us by email

    J'aime

    K
    Kost Ski
    Kost Ski
    04 janv. 2021

    I have same issue. Supports please make update to resolve.

    J'aime

    oren.bar10
    11 déc. 2020

    I have same issue with smart plug devices, it seam that WiFi scan after power up is too short and by the time my Network recover from power up the switch stop trying to connect. Which then i need manually to force it to re-connect by removing it's from power and connect it back to power.

    Is there other solution for this problem?

    J'aime
    7 commentaires
    Posts similaires
    • Configuration of Tasmota WiFi Switch
    • Change Wifi network on my switches
    • Can’t connect to wifi

    ©2020 by athom.