I try to find information about flashing the 'SW11-2EU
EU Touch Switch 2 gang' (with Homekit firmware pre-installed) to Tasmota.
The Homekit version of this switch won't connect to Home Assistant (Homekit connect integration) with code 123-45-678. What makes it useless unless i can flash Tasmota that does connect to HA.
Can someone point me in the right direction?
Hi, I just thought I would add to this my experience with flashing the homekit version to latest HAA version. The process was simple, use the latest HAA Bin file, flash it using the update via the interface at 192.168.4.1. Once flash is complete join the new broadcast wifi on HAA-xxxx add your wifi details and the following JSON (for a 4 gang version). I have used a grouping in this case: {"c":{"b":[{"g":0,"t":5}]},"a":[
{"0":{"r":[{"g":13}]},"1":{"r":[{"g":13,"v":1}]},"b":[{"g":12}],
"es":[
{"0":{"r":[{"g":14}]},"1":{"r":[{"g":14,"v":1}]},"b":[{"g":16}]},
{"0":{"r":[{"g":4}]},"1":{"r":[{"g":4,"v":1}]},"b":[{"g":3}]},
{"0":{"r":[{"g":15}]},"1":{"r":[{"g":15,"v":1}]},"b":[{"g":5}]}]}]}
It can be done. When the switch is in AP mode you have to go to 192.168.4.1/update then you can upload your own bin file. On my 4 gang it just started clicking so you have to do the device recovery after that.
Procedure~
Cut power from the device completely for 30 seconds
Power the device on and off six times with intervals lower than 10 seconds and leave it on after seventh time
Fast power cycle device recovery should activate and the device should be reset to firmware defaults
When you upgrade the firmware to version 0.6 you will get a new code, that code does work with Home Assistant.
Same issue here!
No, i didn't. :( Did you?
Hi. Did you find a way to flash? I have an EU Plug with homekit pre-installed and want it to flash with standard Tasmota.