• Home

  • Products

    • Local Shipping
    • Tasmota
    • ESPHome
    • WLED
    • Homekit
    • Home Bridge
  • Forum

  • About Shipping

  • Contact Us

  • 更多

    Use tab to navigate through the menu items.
    0
    Pour voir cela fonctionner, rendez-vous sur votre site en ligne.
    • Catégories
    • Tous les posts
    • Mes posts
    nateborofsky
    22 juil.

    Have I "soft bricked" my LED controller?

    dans Tasmota Related

    I just bought a LS2812B LED controller with Tasmota. However, when I plug it in to a light strip (I've tried multiple ones), the lights blink, and the controller freezes up. When I unplug the lights, the controller unfreezes.


    I had wanted to upgrade tasmota before using it, and the normal "tasmota.bin.gz" file would not upload (not enough space). So I uploaded the "tasmota-minimal.bin.gz"and then the "tasmota.bin.gz".


    After researching the problem, I came across an old article at www.athom.tech/support. The current page appears to be blank, so I had to use the Internet Archive:

    web.archive.org
    Download | Tasmota Homekit Firmware
    Open sources smart home devices support documents

    This article states, "DO NOT use tasmota-minimal.bin!." Well, that would have been good to know before I did this. Also the "Before upgrading set your device to module 18" part. Is there any way to get this to work again? Is there original Athom-Tasmota firmware that can be downloaded?

    3 commentaires
    0
    3 commentaires

    Partagez vos idéesInscrivez-vous pour laisser un commentaire.

    D
    Digital_Zone
    Digital_Zone
    21 août

    I am incapable of reading articles online very often, but I’m happy I did today. It is very well written, and your points are well-expressed. I request you warmly, please, don’t ever stop writing. soap2day.to

    J'aime

    D
    Digital_Zone
    Digital_Zone
    21 août

    It is a fantastic post – immense clear and easy to understand. I am also holding out for the sharks too that made me laugh. soaptoday

    J'aime

    nateborofsky
    23 juil.

    And…never mind. It appears I plugged the controller into the wrong power supply (it was 12v instead of 5v). I think the led strip I was testing on is fried, but the controller now works fine with other strips (as long as it’s plugged into a 5v supply).

    J'aime
    3 commentaires
    Posts similaires
    • LED Strip Controller disconnects when LEDs connected
    • Controlling led on smart plug PG01
    • Addressable LED strip controller homekit

    ©2020 by athom.