• Home

  • Products

    • Local Shipping
    • Tasmota
    • ESPHome
    • WLED
    • Homekit
    • Home Bridge
  • Forum

  • About Shipping

  • Contact Us

  • 更多

    Use tab to navigate through the menu items.
    0
    Pour voir cela fonctionner, rendez-vous sur votre site en ligne.
    • Catégories
    • Tous les posts
    • Mes posts
    Drew Perttula
    08 déc. 2021

    WLED 7W bulb GPIO configuration

    dans Light

    My new bulbs only displayed green-or-off. I had to go to Config -> LED prefs -> Hardware setup -> GPIOs and fill them in:

    r 4

    g 12

    b 14

    w 13

    c 5




    0 commentaire
    0
    Commentaires

    Partagez vos idéesInscrivez-vous pour laisser un commentaire.

    0 commentaire
    Posts similaires
    • Tasmota to WLED
    • How to factory reset Athom WLED Bulb?
    • Upgrade firmware on 2M 7W bulb from v8.4.0

    ©2020 by athom.